User manual

Bijou
86
13. Fades to position 10 in 6 seconds.
14. Waits 0 seconds before going to position 4
(loop).
15. Fades to position 4 in 1 second.
Many devices have a built-in fade delay. So even
when the device is told to move in 0 seconds, the
device slows the fade automatically.
SPECIAL ATTRIBUTE TIMING
There is a way to have one (or more) attribute(s)
fade faster than the rest.
Example:
The user wants to have the color change at zero
time while the device pans in 10 seconds. The
user needs to go back to the Position Setup
Screen and fill in the time on the desired attrib-
ute.
Rule: The action uses its time unless the attribute
in that position has a time. This means that you
should leave all of the times in the position screen
blank except for the time that needs to move
faster (e.g. color = 0). The action’s default time
needs to be the longest time. This means that
any special attribute times in the Position Setup
Screen must be shorter than the time next to the
position in the Action Screen.
LOOPS
A loop is when a list goes from the last position to
the first. Decide how many times this list should
loop. If the action only runs through the list once
then the number of loops is 0. If the action runs
through the list 4 times then the number of loops
is 3. The user also has the choice of continuous
([F1]). Simply, move the pointer up to LOOPS
and enter the number.
RUNNING AND STOPPING AN ACTION
Example:
Figure 99-Run Action Command