User manual

Bijou
85
the heading POSTION.
6. Press [1], This will select Position 1 as the
first position.
7. Press [Time] [5] [Time] [5] [Enter]. The fade
time is set for 5 seconds to go to position 1
and wait for 5 seconds.
8. Repeat sequence for positions 2, 3, and 4.
This is the series of positions you want to
chain together.
SINGLE STEP
Single step is a way to override the times. If
single step is YES, then press the [Step] button to
move from position to position. This is used to
cycle through the steps when setting up a se-
quence for the first time. Leave it as NO for now.
To override the times:
1. Enter the desired times. Use [Next] and [Last]
to move the pointer to the desired position.
2. Press [Time] once to put in the fade time.
3. Press [Time] twice to put in the delay time.
The Time column shows the length of time it
takes for the device to move from one posi-
tion to another. The Delay column shows how
long the device stays at the position before it
starts fading to the next position.
4. Press [Enter] to confirm.
In the above example, assume that each position
is the same device just moving around the room.
When running, the device:
1. Moves from a 0 setting to position 4 in 1 sec-
ond.
2. Waits 0 seconds before going to position 5.
3. Fades to position 5 in 2 seconds.
4. Waits 2.2 seconds before going to position 6.
5. Fades to position 6 in 3 seconds.
6. Waits 3.7 seconds before going to position 7.
7. Fades to position 7 in zero seconds (snap).
8. Waits 5.1 seconds before going to position 8.
9. Fades to position 8 in 4 seconds.
10. Waits 0 seconds before going to position 9.
11. Fades to position 9 in 5 seconds.
12. Waits 0 seconds before going to position 10.