User manual

Bijou
72
Example:
To load an Effect, select an Effect to run (in this
case, Effect #1), and the Submaster to control it
(for this demonstration, use Sub 24).
To load Effect #1 onto Sub 24, press:
[Sub-master] [2] [4] [Effect] [1] [Enter].
This loads a yellow 01 on the E/Pg: line, directly
above a yellow 24 on the Sub: line of the Sub-
master control section of the Stage Screen. Any
yellow numbers in this section indicates that an
Effect has been loaded to operate with that Sub-
master.
To run the Effect, you can fade it up at any rate
by using the Submaster Fader. Or, you can turn it
ON instantly by using the Submaster bump button
(the instant ON bump button option is best when
using a Single Mode Effect as lighting). Effects
run as long as you have the Submaster up or the
bump button pressed. You can load only one Ef-
fect per Submaster Fader. But, you can run any
or all of them at any time.
The user can have the Submaster Fader control
only an Effect by loading it on a Submaster Fader
that has no prerecorded memory. Or, you can
load an Effect onto a prerecorded Submaster
memory and run them together.
Example:
A case in which you may want to combine an Ef-
fect onto a prerecorded Submaster memory is an
Effect created to flicker lights used to simulate a
fire combined with fixtures focused to give the
impression of the general warm glow from the
fire.
TO CLEAR AN EFFECT OFF OF A
SUBMASTER
To clear an Effect from a Submaster, all you have
to do is press: [Sub-master] [#] [Effect] [Enter].