User manual

Bijou
71
BOUNCE: In a bounce Effect, the sequence
starts at the lowest step and progresses to the
highest number step and then reverses, going to
the lowest number step. Next, the sequence
again reverses and goes back up to the highest
number.
Example:
For a 4-step Effect, the sequence is:
1,2,3,4,3,2,1,1,2,3,4,3,2,1.
REVERSE: This is the exact reverse of Forward.
Reverse starts at the highest and progresses to
the lowest.
Example:
For a 4-step Effect, the sequence is:
4,3,2,1,4,3,2,1,4,3,2,1.
SINGLE: Starts with the lowest numerical step
and progresses to the highest. Unlike Forward,
Bounce, and Reverse, this mode only runs
through the steps one time. This Effect is useful
in creating explosion Effects.
Example:
For a 4-step Effect, the sequence is:
1,2,3,4.
DELETING AN EFFECT
To delete an Effect from the Effect Screen, press
[Delete] [#] [Enter]. This brings up the question,
ARE YOU SURE?, on the command line. To con-
firm that the Effect is ready for deletion, press
[Enter] again.
To delete an Effect from the Stage Screen, press
[Delete] [Effect] [#] (Effect number) [Enter].
RUNNING AN EFFECT
Effects do not automatically run just because you
create them. You have to go to the Stage Screen
to make an Effect operational. Loading an Effect
onto a Submaster runs the Effects.