User manual

Bijou
70
four steps created stays at FULL for a half sec-
ond.
WARNING: You cannot have more than 10
effects loaded onto the submasters at one
time.
WARNING: Many theatrical lighting fixtures
have large filaments that take time to heat up
and start to glow. The filaments also takes
time to cool off and stop glowing once the
power is turned off. If the steps of an Effect
run too fast, the filaments may not have time
to go ON and OFF.
INSERTING AND DELETING STEPS
To insert a step:
1. Go back to the Effect Screen.
2. Press [F2] [#] (step) [F1]
To delete a step:
1. Press [Delete] [F2] [#] (step number for dele-
tion). The command line at the lower left of
the screen reads DELETE STEP #.
2. Press [Enter] to complete the action. This
deletes the desired step, moves up all subse-
quent steps, and renumbers them.
EFFECT TYPES
The Effect that you created has a Default Opera-
tions Mode of Forward. If you press the [F3] key,
the operational choices under Type include:
FORWARD: In a forward Effect, the sequence
starts at the lowest step and progresses to the
highest. Next, the sequence starts over at the
lowest step and progresses to the highest. The
sequence then repeats this process over and
over.
Example:
For a 4-step Effect, the sequence is:
1,2,3,4, 1,2,3,4, 1,2,3,4, 1,2,3,4, 1,2,3,4, 1,2,3,4,
and so on and so forth. Each step active for .5
seconds.