User manual

Bijou
53
10. Press [Load] [6] (Cue) [Enter] to the AB Cross
Faders.
11. Press [Go] to fade into the Cue. When you
press [Go], Cue 6 is faded into and, at the
same time, Cues 7, 8, 9, and 10 are also
faded into.
You now see Cue 5 loaded and ready to fade
into. You also see a new set of dialogs to the left
of the help screen. It reads:
AB PARTS
LEV CUE
7
8
9
10
This shows that you have a multipart Cue ready
to run. As soon as you press [Go], all of the Cues
that are part of the set begin. The LEV column
indicates the progression of the fade in. When all
of the Cues complete, the fade in this section of
the screen clears. At this point, you see that Cue
10 is loaded on the Cross Fader and waiting for
[Go].
The Bijou is capable of running two simultaneous
sets (one on the XY and one on the AB Faders)
of MP Cues, each with four parts. Note that all
MP (multipart) cues
RUNNING CUES OUT OF
NUMERICAL SEQUENCE
LINK
On the Cue List Screen, there is a column for
Link (see Figure 61). To access the Link column,
use the [F2] key.
A link allows you to modify the numerical se-
quence that Cues run in. You create Cues 1-25
and load Cue 1 onto the AB Cross Fader and
cross fade into it. Cue 2 automatically loads to the
other side of the Cross Fader ready for you to
cross fade into it. From this point on as you run
Figure 61-Link Column