User manual

Bijou
48
Screen, you enter:
[5] [At] [5] [Enter].
To set channel 7 thru 10 at a level of 25% from
the Stage Screen, you enter:
[7] [Thru] [1] [0] [At] [2] [5] [Enter].
To set channel 19 at a level 0f 5% from the Stage
Screen, you enter:
[1] [9] [At] [0] [5] [Enter].
To return the levels to their previous settings,
press [At]. [At] addresses the channels again.
After pressing [At], you can hit [Enter] to either
finish or continue on and adjust all brown levels
using the Encoder Wheel (Figure 55). To adjust
the brown levels rotate the Encoder Wheel
counter clockwise to decrease the level. Rotate
the Encoder Wheel clockwise to increase the
level. When finished, press [Enter]. To clear all
the manuals, press [Enter] twice and all of the
manuals will be cleared from the screen.
Practice
If you are just learning the control console and
wish to try features not yet discussed, it is recom-
mended that you record at least 15 Cues into
memory. Cues can have any Cue number from 1
to 1,000 and do not have to be recorded in nu-
merical order. You can skip Cue numbers or in-
sert [.] Cues in between whole number Cues, and
when loaded to a Cross Fader, the Cues play
back in order automatically.
TO CLEAR A CROSS FADER
Sometimes when recording Cues or prior to a
show, you may wish to clear the Cross Faders of
prerecorded Cues. To do so, press [Load] [Enter]
for the appropriate Cross Fader. This is useful for
creating Cues from scratch or a black stage. An-
other way to clear the stage of unwanted chan-
nels is to use the Remainder Dim function.
Figure 55-Encoder Wheel