User manual

Bijou

MEMORY OR AUTOMATED PRESET

OPERATION

Ok, you bought this Memory console so that you

would not have to write down channel levels and

recreate them night after night. All you really want

to do is push the [Go] button at the right time and

the rest is the stage manager’s problem, right?

So, how do you record a set of Cues and play

them back? It is time to learn. Cues can be cre-

ated and played back on either the XY or AB

Cross Faders, but we will start just where we left

off with the board set for 1-scene operation on the

XY Cross Fader.

IF YOU JUST OPENED THE MANUAL TO THIS

SPOT...Complete the following steps before con-

tinuing:

1. Turn ON the board. The board will boot up to

the Stage Screen.

2. Go back to the section on PROTECTING

PRE-RECORDED SHOW INFORMATION.

This will ensure that you do not mess up any

show information that may already be re-

corded in the board and may be needed for a

show that starts in the next hour.

3. Press [Setup] [3] [F2] [Enter].

4. Press [Stage] [F1] [Enter]. This loads the XY

Cross Faders for manual 1-scene operation.

5. Make sure that the Blackout switch is in the

OFF position, that the Grandmaster is in the

full ON position (10), and that the XY fade is

in the up position (near [Load] and [Fade

Take] ).

RECORDING A CUE FROM LEVELS SET WITH

THE CHANNEL FADERS

Example:

To record your first Cue/preset:

1. Press [Stage]. This takes the you to the

Stage Screen.

2. Push Fade Handles 1-10 up to a level of 10

(100%).