User manual

Bijou
33
The Bijou is designed to work in a manual, 2-
scene, preset mode. As we have already done a
Clear All, the system has defaulted to 2-scene
Preset operation with a One-To-One patch. So,
for the time being, Channel 1 operates Dimmer 1
only, Channel 2 operates Dimmer 2, Channel 3
operates Dimmer 3, etc. All are set at a maximum
dimmer output of 100% operating under default
Profile 1.
All 2-scene and 1-scene operations work from the
Stage Screen. This does not mean that you have
to be in the Stage Screen display of the console
to run dimmers but to see the status of the chan-
nels running on stage, look at the Stage Screen.
STAGE SCREEN
The Stage Screen (Figure 38) is used when run-
ning Cues, Submasters, and Effects in 2-scene,
1-scene, and memory modes of operation. At the
top of the screen, you see the title STAGE in
green, BLACK OUT in red, GRANDMASTER in
green, followed by 00 in red. On the far right, is
the clock. If the clock is not set correctly, press
[Setup] [Next] [Next] [Next] [Next] [Next] [Next]
Miscellaneous Functions, and set the hour and
minutes (refer to Section I).
The next vertical block lists channels 1-150 (in
blue). Below each of these numbers is the chan-
nel output level. The channel output levels are
displayed in various colors dependent on where
the level is being generated. You can quickly re-
view all 512 channels levels by using the [Page
Up] and [Page Down] keys.
Directly below the Channel Block is the Operator
Information Block. The left side of the block is, for
now, blank. In the center of the block is the Help
section. On the far right are the [F1], [F2], and
[F3] key functions in magenta.
HELP
The Help section (Figure 39) is designed to assist
Figure 38-Stage Screen
Figure 39-Help section