User manual

Bijou

Neither patch is in use by the board until the

patch is an ACTIVE PATCH. To make the patch

active:

1. Press [Setup] (Default Settings 1 ) [4] Active

Patch [0] for “one to one” patch OR press [1]

for PATCH Page 1 OR [2] for PATCH Page 2

2. Press [Enter] to confirm the active patch.

If you are just learning the system, leave the de-

fault One-To-One patch as the active patch for

now.

On the Patch Screen, there are ninety dimmers

listed at a time with DMR 1-90 listed on the first

screen. DMR (dimmers) are shown as blue num-

bers. Using the [Page Up] and [Page Down] keys

allows you to see 1024 dimmers.

The number of dimmers and DMX devices in your

system limits the number of dimmers that you

need to patch.

PATCH AT LEVEL

DMR (dimmers) are assigned to CHN (Channels/

Faders shown as green numbers) using the

[Thru] [And] [Except] [At] and Number keys

(Figures 32 and 33).

Example:

To make CHN 1 control DMR 3, hit:

[3] [At] [1] [Enter].

This puts the control dimmer 3 onto channel 1

with an output of 100% and Profile 1. Most com-

mon output levels for dimmers is 100%. The LEV

(white) row is left blank unless you input a level

other than 100%.

The Default Profile is 1. If you do not enter a pro-

file for a dimmer, the system assumes Profile 1

and leaves the PRF (brown) row empty. By leav-

ing the LEV (white) and PRF (brown) rows empty,

it is easier to find those dimmers that have spe-

cifically modified the output of the dimmer.

To perform the same function, but give the dim-

mer a maximum output of 80%, the keystrokes

Figure 32-Number Keys

Figure 33-Action Keys