User manual

Bijou
24
1. HHR (Hand Held Remote): If you purchased
a system with the optional Hand Held Re-
mote, this position is toggled [F2] to show
YES. If your system does not have this op-
tion, toggle [F3] to show NO.
2. TIME HOUR: Sets the hour on the system
clock (upper right hand corner of all screens).
To set the time, enter [2] [the hour of the day]
[Enter].
Example:
For 9 o’clock, the entry is: [2] [9] [Enter]. For
11 o’clock, the entry is: [2] [1] [1] [Enter].
3. TIME MINUTE: Sets the minute on the sys-
tem clock. To set the minutes, enter [3] [# of
minutes] [Enter].
Example:
For 15 minutes, the entry is: [3] [1] [5] [Enter].
4. 24-TIME DELAY: Allows the clock to display
time in MILITARY/INTERNATIONAL time.
This needs to be selected if using SMPTE or
MIDI show control functions that are AM and
PM dependent. Select 24 Hour Display be-
fore setting the hour.
The clock should be set to the proper time. The
time remains accurate even with the power
turned off. The board has a built-in battery
backup to protect from memory loss.
The following functions allow the user to pass a
group of channels and their level setting in the
form of a SNAPSHOT. These snapshots are cre-
ated when a submaster has been programmed.
These shapshots are used to program CopyCat
and Subcommander presets. To snapshot a sub-
master, the handle number it is associated with
and the page must be completed in the following
fields.
4. SNAPSHOT PAGE #: Selects the submaster
handle
5. SNAPSHOT HANDLE #: Selects the submas-
ter page
6. SEND SNAPSHOT: Select this field to send a
snapshot out.
Figure 25-Miscellaneous Functions