Specifications

8
ASSEMBLY
ASSEMBLYASSEMBLY
ASSEMBLY
Refer to REAR PANEL for location of appropriate jacks/plugs
for assembly prior to start.
To assemble the Bijou for operation:
First
FirstFirst
First
(with the ‘On/Off’ switch in the off position) plug in the
Universal Power Pack/cord into the ‘Power Input’ jack on the
back of the Bijou. Next plug the parallel blade U-Ground end
into a ‘Surge protected’, outlet.
Like all microprocessor-based controls, the Bijou is sensitive
to power fluctuations on standard power lines. The console
should be plugged into an isolated circuit with a full equipment
ground and a UL approved surge suppresser. It is
recommended, that if a UPS (uninteruptable power supply)
was not part of the original purchase contract, that you
purchase one to protect the console (and your shows). A
UPS can be purchased from EDI or at your local computer or
office supply store.
DO NOT plug the console into the same outlet/circuit with
motors or SCR/TRIAC controlled devices.
Second
SecondSecond
Second
, locate and plug the optional Alpha Numeric keyboard
into its jack on the back or the console.
(NOTE: The Bijou is designed to operate with any standard
PC/AT keyboard. The console can be shipped with a remote
keyboard as optional equipment. If you use a different
keyboard and you encounter problems please contact the
factory, as some manufacturers of AT after market keyboards
have been know to be incompatible.)
Third
ThirdThird
Third
, following the manufacturer’s operations manual,
assemble your VGA/SVGA monitor. Plug in the parallel blade
U-Ground plug into a grounded outlet. Then plug the video
cable into the D15, 3 row, video standard plug on the back of
the control console. Locate the on/off switch on the monitor
and turn it to the on position.
Fourth
FourthFourth
Fourth
, Locate your DMX cable, plug it into the 1-512 DMX
output jack of your console, then plug the other end of the
cord into a DMX input jack connected to your dimmers.
Fifth
FifthFifth
Fifth
, go around to the front of the console and locate the
disk drive on the right end of the control console (when
viewed from an operator’s position). Push the eject button to
eject the plastic protector sheet that was placed in the drive
for transport. Insert any 3.5”, 1.44MB, high-density, PC
format disk into the disk drive.
(NOTE: Unformatted disks must be formatted prior to
recording show information to disk. If you have unformatted
disks they may be formatted on any standard PC.)
Sixth
SixthSixth
Sixth
, reach over the top of the XY and AB cross faders to
the back of the control console. Find the On/Off switch and