Specifications

13
Figure 6 Number Keys
Figure 7 XY & AB Fader Control Keys
NUMBER KEYS
NUMBER KEYSNUMBER KEYS
NUMBER KEYS
NUMBER KEY PAD
Number keys are the primary way to enter values into
the Cues, Times, Submasters and Effects, Number Keys
are always reflected on the system Command Line
(lower left of screen).
NUMBER KEYS [1] thru [0]
Make a selection by entering the value on the Command
Line.
DECIMAL KEY [.]
Used to insert additional steps between whole number
cues or to identify tenth of seconds in timing operations.
FL Key [FL]
Also called FULL, assigns a value of 100% to a level in a
command sequence.
[Enter]
The final keystroke in most command line sequences.
Such as [2][5] [Thru] [3][2] [And] [9][8] [Except] [2][8] [At]
[FL] [Enter]
XY & AB FADER CONTROL KEYS
XY & AB FADER CONTROL KEYSXY & AB FADER CONTROL KEYS
XY & AB FADER CONTROL KEYS
The fader control keys are the primary way of
assigning control functions to the two sets of cross
faders for playback. Fader keys coordinate with the
Fader display on the Stage screen. Fader keys can
load, start, stop, reverse (backup) or take manual control
of a fade.
[Load]
Loads a cue stack on to the desired fader. Operates as
a (ready to fade into) or a “Go To” function (faded into
immediately) dependent on selections made in Setup
Screens.
[Fade Take]
Selects Manual or Automated actions with prerecorded
times for cues loaded to the cross faders.
[Stop/Rev]
Stops the fades in progress on the associated cross
fader. A second press will back up to the previous cue
prior to the [Go].
[Go]
Starts an automated fade loaded to the associated cross
faders.
SETUP SCREENS
SETUP SCREENSSETUP SCREENS
SETUP SCREENS
Before going on to explain operation of the Bijou please
take some time to go through all of options, settings and
functions of the Setup Screens.