User's Manual

Note: If you set the time and date after initial activation, the accuracy of the rainfall
history data may be affected. Reset the unit to clear the history by pressing the RESET
button then set your desired time and date.
•Press the RE-SYNC button.
•Position the Rain Collector/Remote Sensor close to the base unit.
Battery installation of Rain collector
•Press the hook and open the rain collector unit outer case and remove the inner cover 
to access RESET/RE-SYNC buttons.
•Using a coin, unscrew the battery door at the bottom of the rain collector and insert 
(2) AA batteries according to the polarity markings.
•Press the RESET button.
•Replace the battery door.
•Remove the tape from the pendulum inside to
allow it to move freely.
•Close the outer case.
Note : Make sure the battery door is closed
securely to prevent water leakage.
•When the OUT temperature is shown on the display of the base unit, synchronization 
between the base unit and the remote sensor is complete.
POWER UP SYNCHRONIZATION
The base unit will search for the RF signal from the rain collector for 6 minutes after
reset or after batteries are inserted. When the temperature display on the main unit
shows the OUT temperature, synchronization between the base unit and remote unit is
complete.
P.5