INSTRUCTION MANUAL Locations Of Control Main Unit wo EB re-syn BUTTON MAXIMIZATION BUTTON PB cl Ear BUTTON B ‘err Sutton LOCK/TIME SET CALENDAR SWITCH HR/MONTH BUTTON Ll] Min Pate BUTTON WN 12124/YEAR BUTTON I RESET BUTTER BATTERY DOOR LIGHT BUTTON Remote Unit LCD C/F Reset a Battery Door Wall Mount Holder Feature IN temperature and REMOTE temperature Centigrade or Fahrenheit readout Hour and minute display 12 or 24 hour format Calendar with day of week display from January 1, 2000 to December 31, 2030
Maximum and Minimum Temperature record Battery life : approximate 1 year { with alkaline battery ) Operating temperature from 0C to 40C (32F to 104F) Temperature measuring range from —50C to 70C (-58F to 138F) Temperature resolution 0.1C Before You Begin To ensure proper functioning of the RF Thermos Clock, please follow this set up procedure. ® Insert batteries for main unit ( Refer to instructions for battery installation ).
displayed on the Remote temperature field. The main unit will automatically update the remote reading at 3 minutes intervals. If no signals are received within the 10 minutes intervals, blank “- * will be displayed. Check IN / REMOTE Temperature The in door temperature is displayed on the IN temperature field and the remote temperature will be displayed on the REMOTE temperature field. If no reading are received for five consecutive times, blank “~ will be displayed on REMOTE field.
tendency is indicated still, the weather remains unchanged under atmosphere pressure. Tendency Up Tendency Down Tendency — Steady FORECAST FORECAST FORECAST Notes : Upon turning on the power of the Thermometer Weather Station, the weather data can be obtained after about 24 hours. It can forecast the weather for next 6 hour. Do not move the Station while in operation; otherwise, the result will not be reliable.
The stage indicator indicate the following stage of the received signal The unit is in receiving mode ~~ a (TE Transmission data are securely received FE Transmission date are not securely received or no signals -1 Lose Sync. If without obvious reasons the display goes blank, press RE-SYNC to force the receiver to start receive signal. If it still fails, check: ® The remote unit is still in place. ® The batteries of both remote unit and main unit, replace as necessary.
The remote unit comes with a wall mount holder which can hold the unit on wall, or just place it on a flat surface. Reset the RF Thermos Clock Press the RESET button when the RF Thermos Clock does not operate normally. Note: Once resetting the RF Thermos Clock, the main unit will start to receive for 10 minutes { Refer to Getting Started ). Take care of your RF Thermos Clock ® Avoid exposing your RF Thermos Clock to extreme temperatures, water or severe shock.
the clock. ® Do not tamper with any of the internal component of the RF Thermos Clock. This will invalidate the warranty under the above condition. ® Use only fresh batteries. Mixing old and new batteries may cause battery leakage.
and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of more of the following measures: ® Reorient or relocate the receiving antenna.
