User's Manual

Trouble-Shooting
•Press the "Reset" button when the unit is displaying irrelevant temperature reading. This 
 may happen when external noise is severe enough to interfere with the RF temperature 
 signal.
•Press the "Reset" button on the wireless transmitter if the readout is irrelevant or does not 
 respond.
Receiver stage indicator
The RF Temperature signal indicator in the clock's outdoor temperature window will show
the following:
Losing Synchronization of the wireless thermometer
If the main unit displayed a proper outdoor temperature in the past but now displays blank "-
-", the units may have lost synchronization. If this occurs, press the HR/RE-SYNC button of
the main unit. The main unit will attempt outdoor temperature reception for another 6
minutes and reinitiate synchronization with the remote unit. If the remote temperature
cannot be received, check:
1.The distance of the units should be at least 3-4 feet away from any interfering sources
 such as computer monitors or TV sets.
2.Avoid placing the main unit onto or in the immediate proximity of metal window frames.
3.Using other electrical products such as headphones or speakers operating on the same 
 signal frequency (433MHz) may prevent correct signal transmission and reception.
4.Neighbors using electrical devices operation on the 433MHz signal frequency can also 
 cause interference.
Note: When the 433MHz signals is received correctly, do not re-open the battery cover of
either the units, as the batteries may spring free from the contacts and force a false reset.
Should this happen accidentally then reset both unit (see Getting Started above) otherwise
transmission problems may occur.
The maximum transmission range is 100 feet from the remote unit to the main unit (in open
space). However, this depends on the surrounding environment and interference levels.
The temperature signal travels in a straight line from the remote unit to the main unit. The
signal will not curve around blocking object. If no reception is possible despite the
observation of these factors, all system units have to be reset (see Getting Started).
M059M059
P.5
P.6
Interference
Signals from other household devices, such as entry controls, door bells and home security
systems, may temporarily interfere with the units and cause reception failure. This is normal
and does not affect the general performance of the units. The transmission and reception of
temperature reading will resume once the interference has stopped.
Using the Stand
The main unit equipped with a flip stand, you can use the stand to place the main unit on
flat surface, or flip the stand back and hang the main unit on wall with the wall mount holder.
The remote unit comes with a wall mount holder which can hold the unit on wall, or just place it on a flat
surface with the flip stand.
NO SIGNAL DETECTION
SIGNAL DETECTION
SUCCESSFUL RECEPTION
Perspective view from
front and right side
Perspective view from
front and right side
Perspective view from
front and right side
Perspective view from front and left side