Quick Start Guide

Registering Additional Components

For additional components added to your system, register them as follows:

NOTE: For additional keyfobs, see Registering Keyfobs, page 16.

 To register additional components:

1. Remove the component cover.

2. At the control panel, press and hold for about 3 seconds

(disregard the ENTER USER CODE message) until REGISTER and

TRANSMIT 1 display.

3. Now remove the battery protector strip (if you have to remove the

battery in order to do this, make sure the battery is then inserted in

the component with the correct polarity); TRANSMIT 2 displays.

4. Press the component’s tamper switch and then release it; the

(automatically-generated) zone number and SAVE? display.

IMPORTANT: In the listing provided write down the zone

number, component name, and its location / description.

5. Press to save the registration, or press to cancel.

6. Attach the (registered) component’s cover correctly in place.

7. Repeat this procedure from step 3 to register the next component,

or if finished, press to exit the registration mode.

Registering Keyfobs

 To register keyfobs:

1. At the control panel, press and hold for about 3 seconds

(disregarding the ENTER USER CODE message) until REGISTER

and TRANSMIT 1 display.

2. Press any keyfob button; REGISTER and TRANSMIT 2 display.

3. Press the same keyfob button again; the keyfob number and

SAVE? display.

IMPORTANT: In the listing provided write down the keyfob

number, and the user who retains it.

4. Press to save the registration, or press to cancel.

5. Register the next device, or if finished, press to exit the

registration mode.