Quick Start Guide

10

5. At the terminal block connect wire leads for the relevant
connections, as required:

AC power supply terminals

Cable clamp

Terminal block. Connection terminals from left to right:
external module, PGM, zone (for a single hard-wired
peripheral), GND, phone, phone line
6. If the SIM card has not been installed yet, install it now directly
onto the PCB in order to enable GPRS / GSM communication
(see Installing the SIM Card, page 7).
7. When all control panel wiring and the SIM card installation tasks
are finished, close up the control panel casing. Make sure the tabs
on the cover snap into place into their respective grooves, and then
re-install the small screw back onto the front cover.
8. Mount the control panel onto the wall (see Step 2: Installing the
Control Panel, page 11).
