Operation Manual

-56-
The second utility, TX Test enables you to identify transmitters.
In TX Test mode, each time a transmission is received, a chime is sounded and the
activated transmitter is displayed.
To initiate TX Test mode:
1. From the Service menu, select Transmitters, TX Test [7042].
2. Activate a transmitter; the transmitter’s details are displayed.
3. When you have finished, press ̙ to exit TX Test mode.
Signal Strength Tones
1 1 Tone
2 2 – Tones
3 3 Tones
4 4 Tones
The third utility, RF Link enables you to measure the RF noise levels between a selected
transmitter and the system’s receiver.
To view the Environment RF Link level reading:
1. From the Service menu, select RF Link Test [7043]; the first transmitter
on the list is displayed.
2. Using the arrow buttons, scroll through the list and select a
transmitter.
3. Press dž and activate the selected transmitter, e.g. press keyfob button.
The RF noise levels of the selected transmitter and the system’s
receiver are displayed.
The fourth utility, Environmental RSSI enables you to measure the RF noise level of the
systems environment. The Control System will start measuring the RSSI level every
second, and it will display the result on the LCD.
RSSI level can jump momentarily when a detector is activated. It doesn’t mean that the
receiver is noisy.
To view the Environment RSSI level reading:
x From the Service menu, select ENV. RSSI [7044]; the RF noise of the system's
environment is displayed.