Operation Manual

-46-
Call Procedure
To prevent unauthorized attempts to call your Control System, you must enter a user
code when calling your home – see User Codes, Code 29.
To call your home:
1. Call the Control System either using the double call method or directly (see
above); when the Control System picks up, two tones are sounded.
2. Enter the Telecontrol code (Code 29) on your telephone within 15 seconds.
Do not enter your user code until you hear the two tones. Any digits entered before the
tones are sounded are disregarded by the system.
3. A tone is sounded to indicate that the system is ready to receive commands.
The following commands are available:
x Press “2” for Two-Way Audio.
If the TWA mode is defined as “Simplex” (see Simplex Mode), the
audio channel opens in Listen mode (microphone active/speaker
mute). To switch to speak mode, press “1” on your telephone. To
switch back to Listen mode, press “0” on your telephone.
During the TWA session, you can adjust the speaker volume
using the arrow buttons.
x Press “3” to fully arm the system.
x Press "4XX" to turn HA unit #XX ON.
x Press "430" to activate PGM output (Unit 30, 31)
x Press "5XX" to turn HA unit #XX OFF.
x Press "530" to deactivate PGM output (Unit 30, 31)
x Press “6” to disarm the system.
x Press “9” to cancel the siren.
The commands “3” (Full Arm), “4” (HA/PGM On), “5” (HA/PGM Off),
“6” (Disarm) and “9” (Bell Cancel) can also be executed at any time
during a Two-Way Audio session.
Error beeps (three tones) are sounded in case of a wrong command.
To clear the last command, press “º” or “#”.
4. The duration of the call is an option programmed by your installer. Ten
seconds before the end of the call, two short tones are sounded. To extend the
call, press “7” on your telephone.
5. To disconnect before the end of the call, press “¹” then “#” on
your telephone.
Siren Muting
The siren is muted during Two-Way Audio communication. At the end of the call, the
siren is re-activated (if the Siren Cut-Off has not yet expired). You can cancel the re-
activation of the siren by pressing “9” on your telephone during the call.