Operation Manual

-26-
4.4. Arming and Disarming
Figure 9: System Operation Area Page
Three arming modes are available: Away, Part and Perimeter. These modes enable you
to arm your system accordingly to suit different circumstances.
Full Arming Full Arming activates the entire system. This arming method is
used when you intend to leave your home, leaving the premises
empty.
Part Arming Part Arming enables you to arm a section of your home while
remaining on a different part of the premises. For example, at
night your family is upstairs while the area downstairs is armed.
Perimeter Arming Perimeter Arming enables you to turn on the perimeter zones
(the windows and doors of your home) enabling you to move
freely within the protected area.
Combination Arming In addition to the three arming modes, you can activate a combination
of Away and Perimeter or Part and Perimeter arming modes.
Before arming the system, check that all doors and windows are closed so that the
system is ready for arming. System status is displayed on the status bar at the bottom of
the page. If you are arming from a remote location and the system status is "Not Ready",
you may temporarily bypass any zone that is causing this condition.
Disarming can be regarded as turning the security system off. When the system is
disarmed only zones that are defined as active 24 hours are monitored (e.g. Flood, Gas
and Panic zones).