Operation Manual

Quick Reference Guide
Function Press… Additional Information
ARM
FULL PART PERIMETER
If One-Key Arming is disabled
on the Control System, enter
your user code when arming.
The default Master code is
1234.
INSTANT
ARM
Hold down this key until
“Instant Arming OK?” is
displayed. Then Press ¥.
Instant arming cancels the
entry delay after Part or
Perimeter arming. This
feature can be enabled by
your installer.
DISARM [USER CODE] Entering your user code also
silences the siren in the event
of an alarm.
PANIC
ALARM
+
Press these keys together and
hold them down to generate
an alarm.
FIRE
ALARM
+
MEDICAL
ALARM
+
MENU MODE
then [USER CODE] Use the menu navigation keys
(/) until the required
menu item is displayed then
press ¥. Alternatively, enter
the shortcut (e.g. 21 for
Bypass Zones).
CHECK
TROUBLE
CONDITIONS
Use this key scroll the
system trouble list
Pressing  also silences any
trouble tones that may be
sounded by the system.
SWITCH
HA/PGM
UNIT ON
then [HA/PGM UNIT #]
Enter the HA module number
in two digits
(e.g. 03, or 30/31 for PGM).
SWITCH
HA/PGM
UNIT OFF
then [HA/PGM UNIT #]
SERVICE
CALL
Hold down this key until
“Service Call Dialing” is
displayed. The number dialed
for the service call is
programmed by your
installer.
GLOBAL
CHIME
then
Use the menu navigation
keys (/) to choose enable
or disable, then press ¥.
RECORD
MESSAGE
then
After recording a message,
“Message Waiting” is
displayed until the message
is played back.
OR OR