Operation Manual

-17-
3.3. Disarming the System
When you enter the premises, the entry delay begins to count down. You must disarm
the system within the entry delay time to prevent the system from triggering an alarm.
To disarm the system using a keypad:
x Enter your user code.
To disarm the system using a keyfob:
x Press the disarm button – see Keyfobs
To disarm the system using a key switch:
x Open/close the key switch accordingly.
To disarm the System using a Smartkey (if supported):
x Place a registered smartkey against the
center of the smartkey reader of the
Wireless Keypad. When the smartkey is read, the keypad will sound a
beep – the system is disarmed.
3.4. Arm Status Indication and Other System
Status Indication
The system’s arm status is displayed on the front
panel only. The following table explains the
various arm status descriptions that appear on
the LCD display.
Status Means…
DISARMED The system is disarmed.
FULL ARMED
The system has been armed using the displayed arming method.
PART ARMED
PERIMETER ARMED
FULL ARMING
The system is in the process of arming (displayed during exit
delay).
PART ARMING
PERIMETER ARMING
PART ARMED INST
The system has been armed using the displayed arming method
with the Instant arm feature activated.
PERIM ARMED INST
PART ARMING INST
The system is in the process of arming with the Instant arm
feature activated.
PERI ARMING INST
The system may be programmed to display arm status at all times or only for the first
two minutes or 30 seconds after you arm or disarm the system according to the system's
configuration as programmed by the installer.
DISARMED
12:22:12