Operation and programming manual

4
INTRODUCTION
About the Penta Installation, Operation and Programming Manual
This manual is designed to help you with the installation process for the Penta control
panel. We strongly urge you to read through this manual, in its entirety, before beginning
the installation process so that you can best understand all that this security system has
to offer your customers. This manual is not intended for end user use. End users are
encouraged to read the manual accompanying the system, the Penta User Manual. If you
have any questions concerning any of the procedures described in this manual please
contact Electronics Line at (972)-3-9211110 (International) or 1-800-683-6835 (USA).
Publication Information
Catalog Number: ZI0094C (2/99)
CHAPTER ONE: OVERVIEW
1.1: Specifications
Power Input Secondary: 15-16.5Vac, 22-30VA transformer
Battery backup: 12Vdc/3.2Ah
Power Output Auxiliary power: 13.6 - 14.0V (AC operated)
12.0V Nominal (Battery operated)
Bell/siren output: 13.6 - 14.0V (AC operated)
12.0V Nominal (Battery operated)
600mA available for peripheral devices.
The bell/siren output must be supervised by a 2.2K ¼W resistor.
Zones 4 security zones supervised by 2.2K ¼W end of line resistors.
1 tamper/ ON/OFF keyswitch zone
Keypads Up to 3 individually addressed.
Current draw - 100mA max. for each keypad, 200mA max. if
three keypads are installed.
3 user initiated distress keys
User Codes 6 (1 master code, 3 standard user codes, 1 duress code and
1 installer code.
Number of digits per user code – 4
Operating
Temperature
0° to 50°C
Dimensions 260 x 237 x 83mm