Operation and programming manual

Address 10: PGM Options

The PGM (Programmable Output) can be used for indication of certain status or trouble

conditions. When the PGM output is activated terminal 9 switches to ground. Choose

the PGM output setting from the following table.

Value Type Activated By Deactivated By

00 PGM Disabled --- ---

01 System Status System Armed System Disarmed

02 System Status Entry/Exit Tone Follower Entry/Exit Tone Follower

04 System Status System in Communication End of Communication

08 System Trouble AC Loss AC Restore

10 System Status Bell Follower Bell Follower

Event Codes

All events can be programmed to transmit a two digit event code message to the

central station. These codes are usually assigned by the central station - consult the

central station operator/owner for a listing of the different event codes. To disable an

event code program the code as 00. To disable communications program all event

codes as 00.

Address 11: Alarm from Zone 1*

Address 12: Alarm from Zone 2*

Address 13: Alarm from Zone 3*

Address 14: Alarm from Zone 4*

Address 15: Alarm from Tamper Zone*

Address 16: [P] Key alarm*

Address 17: [F] Key alarm*

Address 18: [E] Key alarm

Address 19: Zone 1 Restore

Address 20: Zone 2 Restore

Address 21: Zone 3 Restore

Address 22: Zone 4 Restore

Address 23: Tamper Zone Restore

Address 24: [P] Key alarm restore

Address 25: [F] Key alarm restore

When using the Follow-me feature, program these addresses with a value greater than 00.