Operation and programming manual

10
2.5: Mounting the Keypad
Up to 3 LED keypads can be connected to the Penta control panel. To mount the
keypad:
1. Separate the front and back cover of the keypad by pressing the locking tabs,
situated at the bottom of the keypad, with a small flathead screwdriver.
2. Pull the keypad wires through the opening in the back cover nearest the terminal
block and mount the back cover to the wall.
3. Define the keypad address by configuring jumpers A & B according to the following
diagram.
Jumper
Installed
Jumper
Removed
Keypad 3Keypad 2Keypad 1
B
A
B
A
B
A
Configuration
Jumpers
Buzzer
Tamper
Switch
Terminal
Block