Operation Manual
5
EL-2635 Repeater & Programming keypad – Repeater & Programierbedienteil – Repeteur & Clavier – Repeater & Keypad
Conrad No: 1276483 & 1276484
3.
Confirm registration to the control panel as follows:
When Save? appears on the control panel’s LCD display,
press ./.
REGISTERING TRANSMITTERS TO THE REPEATER
You can register up to 32 transmitters to the EL-2635
repeater.
Note: Do not register the same transmitter to more
than one repeater.
To register transmitters to the repeater:
1.
On the LCD Programming Keypad (EL2635-P),
press
... until 4. TX Register appears on the display.
2.
Press ./;
New Device
appears on the display.
3.
Press
./
again;
Transmit 1
appears on the
display.
4.
Send two transmissions from the device you want
to register.
5.
When the transmitter number and Save? appear
on the display, press
./
to confirm registration.
Figure 4: Transmitter
Registration Procedure
Note: The EL-2635 repeater automatically allocates a transmitter
number
to each newly registered device. Write this number and the zone
number
on the sticker provided with the sensor and stick it inside
the
transmitter’s cover for future reference.
6.
After you have confirmed registration, the display returns to New Device.
Press
./
to register another device or .x to exit Registration mode.
DELETING REGISTERED TRANSMITTERS
To delete transmitters from the repeater’s register:
1.
On the LCD Programming Keypad (EL2635-P),
press
... until 3. TX Delete appears on the display.
2.
Press ./; the first transmitter in the list appears on
the display.
3.
Use the arrow navigation keys (.../...) to scroll to
the transmitter you want to delete.
4.
Press
./
to select the transmitter.
5.
Press
./
again for confirmation; the transmitter is
deleted.
6.
Select another
transmitter to
delete or press .x to
exit.