Installation guide

3. System Programming

3.1. Keys Menu Navigation

Program the CommPact from the keypad located on the main unit (see Table 1).

Enter / Save (to move to the displayed menu or to save the updated data)

Cancel the current selection or return to previous menu

Scroll up or down through the menu options

[1]-[0] 1. Enter numeric values where required.

2. For quick key programming.

Press the number keys to access a programming option.

3. Edit descriptors.

Table 1: Keypad usage

3.2. Enter Engineer Programming mode

1. Go to the default menu and press '√'.

2. Enter your engineer code (default code '1111').

3. Using the arrow keys, select '[9] Programming'

3.3. Selecting a language and Defaults

The CommPact supports several languages. For easy operation, change the system

language as follows:

1. Go to the main menu select [9]>[7]>[1] (Programming > Initialize > Init All)

2. Select default and press

'√'. Select language (Voice + LCD display) and press '√'.

Note:

Setting language and defaults automatically initializes the Control System. All existing

configuration settings are reset to the default settings and all previously registered

transmitter settings are erased.

3.4. Registering Wireless Devices

Every device has to be registered to the Control Panel in order to be recognized.

It is recommended to register all devices to the control panel before installing. To install

the wireless devices/accessories temporarily fit them in the desired locations and then

perform a range test. Testing may show you should relocate the panel or some of its

devices/accessories.

Note:

For wireless sounder registration refer to the full installation manual.