Technical data

3-11 Network Setup

Protocol Setup (TCP/IP)

Enable on Ethernet—Click to enable if you have a TCP/IP network connected to the

Fiery X3 over Ethernet cabling.

You must enable TCP/IP for Ethernet to use the Fiery WebTools over Ethernet. If you

are using TCP/IP for printing from Windows NT 4.0 workstations, enabling TCP/IP

here also enables you to use Fiery utilities from Windows NT 4.0 workstations using

TCP/IP protocols.

IP Auto (Ethernet)—Click to allow the Fiery X3 to obtain its Ethernet IP address by

searching the network. Depending on your network and the protocol you select

(DHCP, BOOTP, or RARP), the IP address can change.

Select protocol (Ethernet)—Select the protocol over which the Fiery X3 should search

for its IP address. Both DHCP and BOOTP allow the Fiery X3 to obtain the Ethernet

IP address and Subnet Mask automatically. RARP obtains only the Ethernet IP

address.

Depending on your network, the Fiery X3 might be assigned a different address after

you reboot the Fiery X3. With the DHCP setting, the Fiery X3 can be assigned a

different address even if it is not rebooted. Make sure the network is already conﬁgured

properly for the protocol you select.

IP Static (Ethernet)—Click to assign the Fiery X3 a static IP address that will not

change.