Technical data

3-10 Setting up the Fiery X3 from a Windows Computer

TO CONFIGURE THE TCP/IP PROTOCOL

• Click the Protocol1 tab in the Network Setup window.

You can change AppleTalk, IPX/SPX, and TCP/IP protocol settings for the Fiery X3

on the Protocol1 and Protocol2 tabs.

The Fiery X3 can accept jobs via TCP/IP (over either Ethernet or Token Ring),

AppleTalk, and IPX/SPX simultaneously. To conﬁgure the Fiery X3, choose each

protocol and enter the settings for that protocol.

Enable Ethernet and, if you have enabled and installed the Token Ring option, enable

Token Ring. If your network uses a gateway, enter the gateway address.

When you set an IP address, subnet mask, or gateway address for the Fiery X3 during

Setup, you can allow the Fiery X3 to get these addresses automatically from a DHCP,

BOOTP, or RARP server. First, turn on or reboot the Fiery X3 and allow it reach Idle.

Next, make sure the DHCP, BOOTP, or RARP server is running. Finally, perform

Fiery X3 Setup.