Technical data

2
2-33 Network Setup options
NOTE: Be sure the administrator configures the printer driver defaults before Windows
NT 4.0 clients install the printer driver with Point and Print. The Fiery X3
Adminstrator name and Password are required during Point and Print installation if
you want to change defaults for the Windows NT 4.0 printer driver.
Use Automatic Configuration
Yes/No [Yes]
This option appears if you chose DHCP or BOOTP as the protocol for automatically
obtaining the IP address of the Fiery X3 (see page 2-16).
Choose Yes to have the Fiery X3 use a WINS name server and automatically obtain its
IP address. After making your choice, you proceed to the Server Name option.
Choose No to proceed to the Use WINS Name Server option, where you specify
whether to use a WINS name server, and then to the WINS IP Address option, where
you specify its IP address.
Use WINS Name Server
Yes/No [No]
Setting up the WINS name server is outside the scope of this manual. To find out if a
name server is available, contact your network administrator.
WINS IP Address
This option appears only if you chose Yes for Use WINS Name Server. Enter the
IP address of the WINS Name Server.
Server Name
Default name
The server name is the name that will appear on the network for accessing the Fiery X3
via SMB. This name can be up to 15 characters long. The default name is the same as
the server name assigned in Server Setup (see page 2-7).
Server Comments
Server comments (optional) can contain information about the printer. These
comments are listed in the Properties of the Fiery X3 in Network Neighborhood.
Comments can be up to 15 characters long.