Technical data

2
2-14 Setting up the Fiery X3
Protocol Setup options
AppleTalk Zone
List of zones
The Fiery X3 searches the network for AppleTalk zones in your network segment.
Scroll through the list to select the AppleTalk zone in which you want the Fiery X3 to
appear. If your segment has only one zone, the Fiery X3 is assigned to that zone
automatically.
The message “No AppleTalk zone found” may mean your network has no zones, or the
network cable is not connected (see page 5-4). Choose OK.
TCP/IP Setup options
To configure the Fiery X3 for TCP/IP, choose TCP/IP Setup.
To configure the Fiery X3, choose each protocol and enter the settings for that
protocol. You can enable AppleTalk, TCP/IP, and IPX/SPX communication
simultaneously.
Network Setup
Protocol Setup
AppleTalk Setup
Enable AppleTalk
Yes/No [No]
Select Yes if you have an AppleTalk network connected to the Fiery X3. This setting
enables the Fiery X3 to communicate over AppleTalk networks.
Enter the appropriate settings for the network type you use (Ethernet or Token Ring).
Token Ring Setup appears as an option only if you have enabled Token Ring in Port
Setup. If your network uses a gateway, enter the gateway address in Gateway Setup.
For information about setting up printing with TCP/IP, see Chapter 4.
Enter the appropriate settings for Ethernet.
For information about setting up printing with TCP/IP, see Chapter 4.
Exit Protocol Setup
AppleTalk Setup
TCP/IP Setup
IPX/SPX Setup
Protocol Setup
Exit TCP/IP Setup
Ethernet Setup
Token Ring Setup
Gateway Setup
TCP/IP Setup
Exit TCP/IP Setup
Ethernet Setup


TCP/IP Setup