Technical data

1-11 Before you begin

Before you begin

The following steps should be completed before you conﬁgure the Fiery X3 and the

workstations that will print to the Fiery X3. A service technician will have performed

some initial installation.

TO PREPARE FOR FIERY X3 CONFIGURATION

1. Print a copier test page to make sure the copier is functioning normally.

2. Turn off the copier and connect the interface cable from the copier to the Fiery X3.

3. To conﬁrm this connection, turn on the copier and the Fiery X3 and print a Test Page

from the Control Panel.

To print a Test Page, press the Menu button on the Control Panel to display the

Functions menu. (See “Fiery X3 Control Panel” on page 2-3.) Choose Print Pages, and

then Test Page.

4. With both the copier and Fiery X3 turned off, connect the network cable to the

Fiery X3, as described in the next section.

The network should already be installed and operational.

5. Turn on the copier and then the Fiery X3.

6. Prepare network servers to share Fiery X3 user software and to enable networked users

to print to the Fiery X3, and proceed to Setup.

See Chapters 2 and 3 for details.