Technical data

5
5-4 Administering the Fiery X3
Network Setup messages
After this Setup screen This message Means
Enable AppleTalk
(Network Setup>Protocol
Setup>AppleTalk Setup)
No AppleTalk zone found.
The Ethernet network cable is not attached to the
connector on the Fiery X3, or the network cable is not
plugged into the hub or network. If your AppleTalk
network has zones, and you want to specify a zone for the
Fiery X3, you must connect the network cable to the
Fiery X3 before performing AppleTalk Setup.
It also could mean that the AppleTalk network does not
have zones. Zones are not required for printing to the
Fiery X3. Press OK to continue.
Protocol Setup or Service
Setup (Network Setup)
You must first enable
a network port.
At least one network port (Ethernet or Token Ring) must
be enabled in Port Setup before Protocol Setup or Service
Setup.
Protocol Setup or Service
Setup (Network Setup)
You must first enable
a network port.
You must enable Ethernet in Port Setup before Protocol
Setup or Service Setup.
Frame Type selection
(Network Setup>Protocol
Setup>IPX/SPX Setup)
Invalid frame size.
The network hub is not connected to a Novell machine
when the Fiery X3 tries to bind.
Warning! IPX network
number is zero.
No other IPX machine can be found on the network, or
the network hub is not connected to the network, when
the Fiery X3 tries to bind. When this occurs, the network
number defaults to zero.
Can’t detect Token Ring
hardware.
Token Ring hardware not
installed or not functioning.
Fiery X3 queries the Token Ring hardware. Error indicates
that some components are not installed, are not installed
correctly, or not installed in the correct device. An
unsupported Token Ring board may be in use. Check with
your authorized service/support center.
Token Ring Setup Can’t autodetect the ring
speed. No device on ring.
The Fiery X3 is trying to detect the current ring speed, but
it is the only machine on the token ring network. Connect
another machine to the token ring network first, before
connecting the Fiery X3.
Enable NDS
(Network Setup>Service
Setup>PServer Setup>
NDS Setup)
No NDS trees found.
No NDS trees were found on the Novell network. Check
that IPX frame types are properly set.