System information

3
If your Fiery Server uses a proxy server on your network, click Proxy Settings.
Note: If you are connected to a Fiery Server with FS150/150Pro, click the Manage link instead.
4
Click Enable Proxy.
Note: If you are connected to a Fiery Server with FS150/150Pro, select Enable HTTP Proxy instead.
5
Type the information about the proxy server, and click Save.
6
Apply or save your changes.
Upgrade the PrintMe subscription
In Configure, you can upgrade PrintMe.
Important: There are two versions of Configure and they are specific to the Fiery Server you are connected to. This
is a combined procedure that describes what to do when connected to a Fiery Server with FS100/100Pro or earlier,
and notes about what to do with FS150/150 Pro or later. If you are not sure which version of Configure you are
using, see Which version of Configure am I using? on page 27.
1
From Configure, choose PrintMe > Upgrade.
Note: If you are connected to a Fiery Server with FS150/150Pro, you can find settings mentioned in this
procedure in Job Submission > PrintMe instead. Click the Upgrade link.
2
Type the information and submit or save your changes.
Exit Configure
After you save your changes, the changes won’t take effect until you reboot the Fiery Server.
•
Do one of the following:
• Reboot the Fiery Server so that the changes take effect.
• If you do not want to reboot the Fiery Server yet, quit or log out to exit Configure. The changes are saved.
Some changes are not activated until the Fiery Server is rebooted.
About backup and restoring
You can back up and restore several categories of settings (if your Fiery Server supports them).
•
Fiery settings (includes all the settings selected in Configure)
•
Color settings (includes profile edits made with Color Editor, user-added profiles, spot colors, and substitute
colors)
•
Preflight presets
Fiery Command WorkStation
Configuring server settings
70