System information

Configure Set Page Device (SPD) media mapping

Set Page Device (SPD) commands are instructions within PostScript, VIPP, and VPS files that specify certain

attributes of a print job.

Important: There are two versions of Configure and they are specific to the Fiery Server you are connected to. This

is a combined procedure that describes what to do when connected to a Fiery Server with FS100/100Pro or earlier,

and notes about what to do with FS150/150 Pro or later. If you are not sure which version of Configure you are

using, see Which version of Configure am I using? on page 27.

You can enable SPD Media Mapping to allow the Fiery Server to recognize and apply some of these attributes,

including:

•

Paper attributes (for example, Media Type and Media Color)

•

Finishing attributes (for example, stapling or folding)

•

Generic attributes (for example, number of copies)

From Configure, select PDL.

Note: If you are connected to a Fiery Server with FS150/150Pro, click RIP and select the Set Page Device

check box instead.

Click SPD.

Select Enable Set Page Device Mapping.

Apply or save your changes.

Once enabled in Configure, the SPD mapping option is available in Job Properties.

Next steps

For information about Fiery Server options that appear in Job Properties, see Printing, which is part of the user

documentation set.

Set up PrintMe

Use these options to define settings for PrintMe cloud printing. Users can upload a document to the PrintMe cloud

service and then print the document to the copier/printer from the Fiery Control Panel.

Enable PrintMe cloud printing

When you enable PrintMe, you may need to specify information about the proxy server.

Important: There are two versions of Configure and they are specific to the Fiery Server you are connected to. This

is a combined procedure that describes what to do when connected to a Fiery Server with FS100/100Pro or earlier,

and notes about what to do with FS150/150 Pro or later. If you are not sure which version of Configure you are

using, see Which version of Configure am I using? on page 27.

From Configure, choose PrintMe.

Note: If you are connected to a Fiery Server with FS150/150Pro, you can find settings mentioned in this

procedure in Job Submission > PrintMe instead.

Click Enable PrintMe.

Fiery Command WorkStation

Configuring server settings