System information

Select a value for the Timeout, which defines how long the Fiery Server should wait for the next job in the

sequential run, before timing out and considering the run complete.

Select Publish Sequential Print Queue to make the Sequential Print Queue available via all supported

printing protocols and from Command WorkStation, virtual printers, and Hot Folders.

Apply or save your changes.

Configure PDL

Use PDL (printer description language) pages to define default settings for jobs.

Configure PostScript settings

You can configure settings that affect PostScript jobs. These settings affect jobs for which users have not specified a

setting.

Important: There are two versions of Configure and they are specific to the Fiery Server you are connected to. This

is a combined procedure that describes what to do when connected to a Fiery Server with FS100/100Pro or earlier,

and notes about what to do with FS150/150 Pro or later. If you are not sure which version of Configure you are

using, see Which version of Configure am I using? on page 27.

Some combinations of settings may not be appropriate (for example, specifying duplex printing on transparencies). If

you specify an inappropriate combination of settings, no error message appears.

From Configure, choose PDL > PS.

Note: If you are connected to a Fiery Server with FS150/150Pro, you can find settings mentioned in this

procedure in RIP > PS settings instead.

Specify settings for the options.

Apply or save your changes.

Next steps

For information about PostScript settings, see Configuration and Setup, which is part of the user documentation set.

Configure PCL settings

If your Fiery Server supports PCL, you can set the default settings for the following options that affect all PCL jobs.

Important: There are two versions of Configure and they are specific to the Fiery Server you are connected to. This

is a combined procedure that describes what to do when connected to a Fiery Server with FS100/100Pro or earlier,

and notes about what to do with FS150/150 Pro or later. If you are not sure which version of Configure you are

using, see Which version of Configure am I using? on page 27.

These settings affect jobs for which users have not specified a setting. Some combinations of settings might not be

appropriate (for example, specifying duplex printing on transparencies). If you specify an inappropriate combination

of settings, no error message appears.

From Configure, choose PDL > PCL.

Note: If you are connected to a Fiery Server with FS150/150Pro, you can find settings mentioned in this

procedure in RIP > PCL settings instead.

Fiery Command WorkStation

Configuring server settings