System information

3
If your network uses IPv6 addresses, select Enable IPv6.
Note: While it may be possible to disable IPv4 and enable IPv6, IPv4 must be enabled for IPv6 to work.
Note: If you are connected to a Fiery Server with FS150/150Pro, click Network > IPv6 Address and select
Enable IPv6 Address instead.
4
Choose whether to obtain the gateway address automatically or manually.
Note: If you are connected to a Fiery Server with FS150/150Pro, you must perform this action from
Network > IPv4 Address. Configure IP Address must be set to Manual first and your must type an IP
address in the Default Gateway field manually.
5
Apply or save your changes.
Set TCP/IP addresses for the Fiery server manually
When you set TCP/IP addresses manually, you specify the IP address, subnet address, and make specifications
about the gateway address.
Important: There are two versions of Configure and they are specific to the Fiery Server you are connected to.
This is a combined procedure that describes what to do when connected to a Fiery Server with FS100/100Pro or
earlier, and notes about what to do with FS150/150 Pro or later. If you are not sure which version of Configure
you are using, see Which version of Configure am I using? on page 27.
1
From Configure, choose Network > Protocol > TCP/IP > Ethernet.
Note: If you are connected to a Fiery Server with FS150/150Pro, you can find settings mentioned in this
procedure in the following locations instead:
• Network > IPv4 Address
• Network > IPv6 Address
instead.
2
In the Select IPv4 address, section, select manually.
Note: If you are connected to a Fiery Server with FS150/150Pro, select Manual instead.
3
Type the IP address and subnet address in the respective fields.
4
If your network uses IPv6 addresses, select Enable IPv6.
Note: If you are connected to a Fiery Server with FS150/150Pro, click Network > IPv6 Address and select
Enable IPv6 Address instead.
5
Select one of the following in the Select Gateway address section:
• Automatically - The Fiery Server obtains a gateway address automatically.
• Manually - Type an IP address for the gateway in the IP Address field.
Note: If you are connected to a Fiery Server with FS150/150Pro, you must perform this action from
Network > IPv4 Address. Configure IP Address must be set to Manual first and your must type an IP
address in the Default Gateway field manually.
6
Apply or save your changes.
Fiery Command WorkStation
Configuring server settings
60