System information

Choose the default print connection.

Apply or save your changes.

Configuring protocols

When you specify TCP/IP settings, you can assign addresses automatically from a DHCP or BOOTP server.

If you use this approach, make sure that the appropriate server is running before configuring the settings for TCP/IP

for Ethernet, DNS, WINS Server, security, IPsec, or certificates.

Configure TCP/IP for Ethernet

You can specify that the Fiery Server obtains its IP address automatically or set the address manually.

Before you begin

Note: The Fiery Server stores assigned IP addresses, even if you disable TCP/IP later. If you must assign the Fiery

Server IP address to another device, first set the Fiery Server address to the loopback address (127.0.0.1).

The Fiery Server requires a unique, valid IP address. You can specify that the Fiery Server obtains its IP address

automatically or set the address manually. If you allow the Fiery Server to obtain the IP address automatically, it also

obtains the gateway address automatically.

If you want to set other kinds of IP addresses automatically, such as for a DNS or WINS server, you must allow the

Fiery Server to obtain its own IP address automatically.

Allow the Fiery server to obtain its TCP/IP address automatically

For the Fiery Server to obtain its IP address automatically, you make specifications about the protocol. You can

have the Fiery Server obtain the gateway address automatically or manually.

Important: There are two versions of Configure and they are specific to the Fiery Server you are connected to.

This is a combined procedure that describes what to do when connected to a Fiery Server with FS100/100Pro or

earlier, and notes about what to do with FS150/150 Pro or later. If you are not sure which version of Configure

you are using, see Which version of Configure am I using? on page 27.

From Configure, choose Network > Protocol > TCP/IP > Ethernet.

Note: If you are connected to a Fiery Server with FS150/150Pro, you can find settings mentioned in this

procedure in the following locations instead:

• Network > IPv4 Address

• Network > IPv6 Address

In the Select IPv4 Address section, select automatically.

Note: This setting can obtain both the IP address and gateway address for the Fiery Server, or you can

choose to set the gateway address manually.

Note: If you are connected to a Fiery Server with FS150/150Pro, select Automatic instead.

Fiery Command WorkStation

Configuring server settings