System information

Select Enable TCP/IP Port Filter and enable the following ports:

• 80 (HTPP)

• 631 (IPP)

• 5353 (Multicast DNS)

Click Job Submission and do the following:

a) Click Queues and select Publish Print Queue.

b) Select IPP.

c) Click Web Services for Devices (WSD) and select Enable WSD.

d) Click Direct Mobile Printing and select Enable Direct Mobile Printing.

Click Network > Bonjour and select Enable Bonjour.

Configure SLP

The Service Location Protocol (SLP) is a service discovery protocol that allows computers and other devices to find

services in a local area network without prior configuration.

Important: There are two versions of Configure and they are specific to the Fiery Server you are connected to. This

is a combined procedure that describes what to do when connected to a Fiery Server with FS100/100Pro or earlier,

and notes about what to do with FS150/150 Pro or later. If you are not sure which version of Configure you are

using, see Which version of Configure am I using? on page 27.

From Configure, choose Network > Services > SLP.

Note: If you are connected to a Fiery Server with FS150/150Pro, you can find settings mentioned in this

procedure in Network > Service Location Protocol (SLP) instead.

Select Enable SLP.

Define an additional Scope to be included with the published SLP services.

Apply or save your changes.

Configure Web Services for Devices (WSD)

Web Services for Devices (WSD) allows computers to discover printers and other devices on the network. You must

enable port 3702 (WS-Discovery).

Important: There are two versions of Configure and they are specific to the Fiery Server you are connected to. This

is a combined procedure that describes what to do when connected to a Fiery Server with FS100/100Pro or earlier,

and notes about what to do with FS150/150 Pro or later. If you are not sure which version of Configure you are

using, see Which version of Configure am I using? on page 27.

From Configure, choose Network > Services > WSD.

Note: If you are connected to a Fiery Server with FS150/150Pro, you can find settings mentioned in this

procedure in Job Submission > Web Services for Devices (SWD) instead.

Select Enable WSD.

Fiery Command WorkStation

Configuring server settings