System information

For information about setting up a Windows computer for Windows printing, see Printing, which is part of the user

documentation set, and your Windows documentation.

From Configure, choose Network > Services > Windows Printing (SMB).

Note: If you are connected to a Fiery Server with FS150/150Pro, you can find the settings mentioned in this

procedure in Job Submission > Windows Printing instead.

Select Enable Windows Printing (SMB).

If your Fiery Server supports both PostScript and PCL, select the type of printer driver that is available for users

to download when they install printer drivers with the Point and Print method of installation.

Apply or save your changes.

Configure LPD

You can configure Line Printer Daemon (LPD) printing.

Before you begin

For LPD printing, you must enable TCP/IP on the Fiery Server

Important: There are two versions of Configure and they are specific to the Fiery Server you are connected to. This

is a combined procedure that describes what to do when connected to a Fiery Server with FS100/100Pro or earlier,

and notes about what to do with FS150/150 Pro or later. If you are not sure which version of Configure you are

using, see Which version of Configure am I using? on page 27.

From Configure, choose Network > Services > LPD.

Note: If you are connected to a Fiery Server with FS150/150Pro, you can find the settings mentioned in this

procedure in Job Submission > LPD instead.

Select Enable LPD Printing.

Note: If you are connected to a Fiery Server with FS150/150Pro, select Enable.

Select the print connection on the Fiery Server to which LPD jobs are sent.

In addition to the standard print connections Print queue and Hold queue, published virtual printers (if

supported by your Fiery Server) are also listed.

Apply or save your changes.

Configure Port 9100

Enabling Port 9100 services allows applications to open a TCP/IP socket to the Fiery Server at Port 9100 to download

a print job.

Important: There are two versions of Configure and they are specific to the Fiery Server you are connected to. This

is a combined procedure that describes what to do when connected to a Fiery Server with FS100/100Pro or earlier,

and notes about what to do with FS150/150 Pro or later. If you are not sure which version of Configure you are

using, see Which version of Configure am I using? on page 27.

From Configure, choose Network > Services > Port 9100.

Note: If you are connected to a Fiery Server with FS150/150Pro, click Job Submission > Port 9100 instead.

Fiery Command WorkStation

Configuring server settings