System information

2
Do one of the following:
• Click Print, select the printer to send your Server Configuration page to, and then click Define if you want to
specify different job properties for the print job from what is currently set as default on the Fiery Server. Click
Print again to print the page.
• Click File > Print > Server Configuration. A Server Configuration page is sent to the printer you are
currently connected to. The page prints with the default paper size and options of the Fiery Server.
Access Configure
Use Configure to set up the Fiery Server. Setup is required the first time the Fiery Server is turned on or after system
software is installed. You also use Configure to specify information about the network environment and printing
preferences for jobs that users send to the Fiery Server.
1
Connect to the desired Fiery Server, log in as an Administrator, and access Configure one of the following ways:
• Click Device Center > General > Configure.
• Click Device Center > Users > Configure.
• Choose Server > Configure.
2
Change current Fiery Server Setup options.
Note: Some Configure options may not be supported by your Fiery Server.
Next steps
For information about Configure options not discussed in this Help, see Configuration and Setup, which is part of
the user documentation set.
Which version of Configure am I using?
There are two versions of Configure, and they are specific to the Fiery Server you are connected to. For example, you
may connect to a Fiery Server and see one version of Configure, and then connect to another Fiery Server and see a
Configure with a significantly different, improved interface.
For example:
•
If the Fiery system software is FS100/100Pro or earlier, the Fiery Server uses the older version of Configure.
•
If the Fiery system software is FS150/150Pro or later, the Fiery Server uses the latest version of Configure.
The following types of topics about Configure exist:
•
Procedures that are specific to only FS100/100Pro or earlier.
•
Procedures that are specific to only FS150/150Pro or later.
•
Combined procedures that describes what to do when connected to a Fiery Server with FS100/100Pro or earlier,
and notes about what to do with FS150/150 Pro or later.
If a topic does not include FS100/100Pro or FS150/150Pro in the title, it is a combined procedure.
1
In Command WorkStation, click Device Center.
Fiery Command WorkStation
Configuring server settings
27