System information

3
From the Cover Content input menu, do one of the following:
• To insert a pre-printed cover, select Pre-Printed. The pre-printed cover will be merged with the body pages of
your booklet, which print separately. If you select this option, the Front Cover and Back Cover options are
disabled.
• To specify an inline cover, select Front & Back Separately. Specifying this option prints the cover pages and
body pages as a single job. Separate pages from your document are imposed on a single sheet that forms the
cover of your booklet.
You can specify an inline cover when your original document includes the cover pages and/or cover artwork
for your booklet. The cover content may be the first and last pages of your document, or the first two and last
two pages of your document, or any combination. If you select this option, you can specify the Front Cover
and Back Cover options.
• Front Cover and Back Cover (Inline covers only) - These options allow you to quickly decide whether your
front and back covers print duplex (on both sides of the sheet), single-sided, or both sides blank, without
needing to add blank pages in your original document.
Note: When you print an inline cover with top-edge binding, the outside back cover automatically rotates 180
degrees to match the orientation of the front cover.
4
Click Define Cover to open the Cover Media settings window, to specify media, size, and source tray. This
option is available for both pre-printed and inline covers.
5
Specify the media and paper size for the pre-printed insert, or for your inline covers.
6
Select the tray that contains the pre-printed inserts or inline covers, and click OK.
Change the document size within an application
Change the size of your original document in the Print Setup of the application in which you created the document.
Before you begin
Before you change the document size, to make sure your copier/printer supports the paper size.
1
Open your original document and choose File > Print Setup (or File > Page Setup).
2
Select your copier/printer from the Printer Name menu.
3
Select from the list of available paper sizes, and click OK.
Note: When you select a paper size from the available list, you do not need to consider the edge feed of the
paper.
Change the unit of measurement
You can use millimeters, point, or inches for measurement.
Note: In the printer driver, it is not possible to change the unit of measurement.
1
In Command WorkStation, go to Edit > Preferences.
2
Click the Size tab.
3
Select the unit of measurement (millimeters, points, or inches), and click OK.
Fiery Command WorkStation
Booklet Maker
246