System information

•
Select Booklet in the Layout tab of Command WorkStation Job Properties and follow the prompts to set the
Align pages option.
• At the spine (default) - Aligns document page content flush with the spine, at the center of the sheet where
the fold will occur.
A A
• At the center - positions document page content at the center of one-half of the sheet size.
A
A
Aligning pages with the Shrink to fit option
You can choose to align pages with the Shrink to Fit option On (enabled) or Off (disabled).
Aligning pages with Shrink to fit On
The following illustration shows page alignment when the document size is less than (<) one-half of the paper size:
A
A
A A
A
1 Document size < one-half paper size
2 Pages aligned at the spine
3 Pages aligned at the center
The following illustration shows page alignment when the document size is equal to one-half of the paper size, in
which case there is no visible difference:
A
A
AA
A
1 Document size = one-half paper size
2 Pages aligned at the spine
3 Pages aligned at the center
Note: When the document size is greater than one-half of the paper size and Shrink to fit is On, the final printed
result is determined by the aspect ratio of the original document.
Fiery Command WorkStation
Booklet Maker
238