System information

Note: In Windows, you can select a point and use the arrow keys to move the point 1% in any direction, or to

move a large amount, hold down the Shift key and press an arrow key.

• To delete a point on a curve, select the point and press Delete.

You can also select a point and drag it over the point you want to delete.

• In Windows, move from point to point by selecting one point on the curve and using Shift-Page-Up and Shift-

Page-Down.

Edit colors using the color wheel

For a color job, you can edit colors using the color wheel in the Color Adjust pane.

Note: The edits that you make using the color wheel are kept if you switch to the Curves tab. But edits that you

make using curves are lost if you switch to the Color Wheel tab without first saving the job.

Click the Color Wheel tab in the Color Adjust pane.

Click a tonal range (Highlights, Overall, or Shadows) to set the tonal range for the edit.

Note: The tonal range selection does not apply to Brightness. Brightness always applies to the entire tonal

range.

To edit hue and saturation, click a new location inside the color wheel.

The image preview changes to show the result of the edit.

Fine-tune the edit by dragging the sliders for Hue, Saturation, Black, or Brightness, or type a new numeric

value to the right of the slider.

Edit gray response curve through image

For a black-and-white Fiery Server, you can use the gray response curve in the Curve Edit pane to make precise edits

to the gray response of a job.

Edits to the gray response curve apply to all pages of the job.

Note: The response curve under Curve Edit is not the response curve of the Fiery Server. In a processed job, the

gray levels have already been converted by the Fiery Server.

Move the cursor in the image to an area of gray that you want to adjust.

An image may contain many levels of gray in a small area. Make sure that you enlarge the image enough to locate

the desired gray precisely.

Ctrl-click at the cursor location.

The point on the response curve that corresponds to the gray level at the location is highlighted.

Move the selected point to the desired location using the arrow keys (Up for darker, Down for lighter) to adjust

the response curve.

Fiery Command WorkStation

Graphic arts tools

220