System information

Click OK to save the Control Bar.

Export, import, or delete a custom Control Bar

You can export a custom Control Bar from the Fiery Server to your computer as a file and share the local copy or

import it to another Fiery Server. Imported Control Bars are added to the list in the Control Bar tab and are

immediately enabled for use on the Fiery Server.

Note: You can delete a custom Control Bar from the list but you cannot delete the default Control Bar.

In Device Center, click the Color Setup tab and click Control Bar.

in the Control Bar window, do one of the following:

• To export the Control Bar, click Export, browse to the location where you want to save the file, and click OK.

• To import the Control Bar, click Import, locate and select the desired Control Bar, and click Open.

Note: If the imported Control Bar as the same name as an existing Control Bar in the list, you are prompted to

rename the Control Bar.

To delete the custom Control Bar, select a Control Bar in the list, click Delete, and then click Yes to confirm.

Restore the default Control Bar

You can delete all user-defined Control Bars and restore the default Control Bar to its original state.

In Device Center, click the Color Setup tab and click Control Bar.

Select a Control Bar in the list and click Edit.

Click Factory Default and click OK.

Trapping

Trapping is a technique to prevent white edges around objects, or “halos,” caused by the misalignment of color

plates. With trapping, objects are printed with slightly enlarged edges, or traps, to fill any gaps between objects.

Trapping is applied to a job when the Auto Trapping print option is enabled.

If configurable Trapping is supported by your Fiery Server, you have full control over the trapping settings used by

the Auto Trapping print option. The factory default settings of the Fiery Server are optimized for the copier/printer

using regular paper. Many jobs print satisfactorily with the default trapping settings, but if they do not provide the

results necessary for the media that you use, configure the trapping settings to meet your requirements.

For more information about Auto Trapping, see Color Printing, which is part of the user documentation set.

Set default auto trapping for all jobs

Selecting the Use Trap Settings by Default option sets the Fiery Server default value of the Auto Trapping print

option to On and applies trapping to all jobs sent to the Fiery Server by default.

In Device Center, click the Color Setup tab and click Trapping.

Select Use Trap Settings by Default.

Fiery Command WorkStation

Graphic arts tools

211