System information

2
Specify Sample Print option settings as desired.
• Frequency - Specify Every or On-demand. When you select Every, the Fiery Server prints a sample
repeatedly as defined by the printed sheet(s) interval. A sample print can be printed for all jobs until the Fiery
Server is restarted or the sample print mode is canceled, or for the current job only until it finishes printing or
is canceled. When you select On-demand, a single sample is printed.
Note: Printed sheets include all pages printed by the Fiery Server, including system pages.
• Content - Specify Sheet (for any kind of job) or Sheet (for uncollated job) / Set (for collated jobs).
When you select Sheet (for any kind of job), a single sheet is printed as the sample. If the job is collated, an
entire output set is printed as the sample. If the job is uncollated, a single sheet is printed as the sample. If the
sample content is a set and the printed sheet interval triggers the Fiery Server to print a sample, the Fiery
Server will begin printing the sample at the beginning of the next set.
• Output Tray - Specify the output tray for the sample print jobs. All installed output trays that do not require
finishing options are listed.
Note: The job's finishing options are not applied to the sample print job, except for duplex options.
3
After you have changed the setting for an option, do one of the following:
• On FS100/100 Pro or later: Click Undo or Apply.
• On FS150/150 Pro or later: Click Cancel or Save.
4
Restart the Fiery Server.
Proof Print
Use Proof Print to print a proof (copy) to check the printed output of your job without changing the job's original
copy count.
When you apply Proof Print to your job, the selected job is sent to the Printing queue with the number of copies set
to one. The original job retains the specified number of copies and job properties and uses the raster data that was
created from the proof print to print subsequent jobs.
If you apply Proof Print to a processed job (with a raster), the job goes directly to the Printing queue and does not
process again unless a change is made to the job.
Proof Print jobs appear in the Job Log with the number of copies set to one.
Additionally, you can use Sample Print to print extra pages to an output tray during a long print job to verify that the
copier/printer is performing as expected.
Print a proof
You can use Proof Print by right-clicking on a job in the Held or Printed list, or you can access the command from
the Actions menu or from job actions within Job Properties and Hot Folders.
•
Do one of the following:
• From Job Center, right-click a job in the Held or Printed list and select Proof Print.
• Click Actions > Proof Print.
Fiery Command WorkStation
Printing
109