Installation guide

5
5-14 Setting up the Fiery from a Windows Computer
To set the subnet mask, enter one of the following values:
255.0.0.0 if the IP address starts with a number less than 128
255.255.0.0 if the IP address starts with a number from 128 through 191
255.255.255.0 if the IP address starts with a number greater than 191
NOTE: Confirm the subnet mask setting with your network administrator before
proceeding. In some cases, the required setting may be different from those listed.
If your TCP/IP network has a gateway and users outside the gateway plan to print to
the Fiery using TCP/IP, enter the gateway address.
In remote Setup, the Token Ring information appears, even if you have not enabled
Token Ring on the Fiery.
NOTE: The Fiery stores assigned IP addresses, even if you later disable TCP/IP. If you
need to assign the Fiery IP address to another device, first set the Fiery address to a null
address.