Installation guide

5-13 Network Setup

TCP/IP

Specify TCP/IP settings. The current settings for IP address, subnet mask, and default

gateway address are displayed. For information about setting up printing with TCP/IP,

see Chapter 2.

The Fiery requires a unique, valid IP address. You can set a static address or specify that

the Fiery use DHCP, BOOTP, or RARP to obtain IP addresses automatically.

NOTE: If you specify the DHCP, BOOTP, or RARP protocol, the Fiery reboots when

you save your changes and exit Setup. Allow the Fiery to reboot and return to Idle

before printing a Conﬁguration page or proceeding with any other operations.