Technical data

4
4-10 Setting up the Fiery from a Windows Computer
Parallel Port Timeout (seconds)—Available only if Enable Parallel Port is selected, this
setting determines how long the Fiery waits without receiving data from the parallel
port before deciding that the current job is complete. Until the timeout, the Fiery can-
not receive new jobs through the parallel port, but it can continue to receive network
print jobs.
Token Ring (Port Setup)
Enable Token Ring—Select if the Fiery is connected to a Token Ring network.
Maximum Frame Size—Select the maximum frame size recommended by the network
administrator at your site. If you are uncertain of the setting to use, select the default
value (4202).
Transmission Speed—Select Auto Sense if your network environment is mixed, or
select the speed (4 Mbps or 16 Mbps) of the network to which the Fiery is attached.
Enable Source Routing—Select if your network supports source routing.
Request All Routes—This option is active only if you enabled Source Routing. Select
if you want the Request packet to travel to its destination by all routes.
Respond All Routes—This option is available only if the previous option is not
selected. Select if you want the Response packet to return by all routes to the originat-
ing computer.